Dell Force10 TeraScale E Series - Page 674

674 | IPv4 Routing
www.dell.com | support.dell.com
show ip route list
c e s
Display IP routes in an IP prefix list.
Syntax
show ip route list prefix-list
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Table 24-14. show ip route all Command Example Fields
Field Description
(undefined) Identifies the type of route:
•
C = connected
•
S = static
•
R = RIP
•
B = BGP
•
IN = internal BGP
•
EX = external BGP
•
LO = Locally Originated
•
O = OSPF
•
IA = OSPF inter area
•
N1 = OSPF NSSA external type 1
•
N2 = OSPF NSSA external type 2
•
E1 = OSPF external type 1
•
E2 = OSPF external type 2
•
i = IS-IS
•
L1 = IS-IS level-1
•
L2 = IS-IS level-2
•
IA = IS-IS inter-area
•
* = candidate default
•
> = non-active route
• + = summary routes
Destination Identifies the route’s destination IP address.
Gateway Identifies whether the route is directly connected and on which interface the route is
configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
prefix-list
Enter the name of a configured prefix list.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series