Dell Force10 TeraScale E Series - Page 758

758 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Command
History
Usage
Information
Enter the no debug ip bgp command to remove all configured debug commands for BGP.
default-metric
c e
Allows you to change the metrics of redistributed routes to locally originated routes. Use this
command with the redistribute command.
Syntax
default-metric number
To return to the default setting, enter no default-metric.
Parameters
Defaults
0
Command Modes
ROUTER BGP
Command
History
Usage
Information
The default-metric command in BGP sets the value of the BGP MULTI_EXIT_DISC (MED) attribute
for redistributed routes only.
Related
Commands
description
c e
Enter a description of the BGP routing protocol
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
ROUTER BGP
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
number
Enter a number as the metric to be assigned to routes from other protocols.
Range: 1 to 4294967295.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
bgp always-compare-med Enable comparison of all BGP MED attributes.
redistribute Redistribute routes from other routing protocols into BGP.
description
Enter a description to identify the BGP protocol (80 characters maximum).