766 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Defaults
threshold = 75
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
If the neighbor maximum-prefix is configured and the neighbor receives more prefixes than allowed by
the neighbor maximum-prefix command configuration, the neighbor goes down and the show ip bgp
ipv6 unicast summary command displays (prfxd) in the State/PfxRcd column for that neighbor.
The neighbor remains down until you enter the capture bgp-pdu max-buffer-size command for the
neighbor or the peer group to which the neighbor belongs or you enter neighbor shutdown and
neighbor no shutdown commands.
Related
Commands
neighbor X:X:X::X password
c e
t
Enable TCP MD5 Authentication for an IPv6 BGP peer session.
Syntax
neighbor x:x:x::x password {7 <encrypt-pass> | <clear-pass}
To return to the default setting, use the no neighbor x:x:x::x password command.
Parameters
Defaults
Disabled.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
The TCP session is authentication and hence prevents the data from being compromised.
threshold
(OPTIONAL) Enter a number to be used as a percentage of the
maximum value. When the number of prefixes reaches this percentage
of the
maximum value, the E-Series software sends a message.
Range: 1 to 100 percent.
Default: 75
warning-only (OPTIONAL) Enter the keyword warning-only to set the router to
send a log message when the maximum value is reached. If this
parameter is not set, the router stops peering when the maximum number
of prefixes is reached.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
show ip bgp ipv6 unicast summary Displays the current BGP configuration.
encrypt-pass
Enter the encrypted password.
clear-pass
Enter the clear text password.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series TeraScale
To Next Page
Loading...
