Dell Force10 TeraScale E Series - Page 767

IPv6 Border Gateway Protocol (IPv6 BGP) | 767
neighbor next-hop-self
c e
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for
IBGP).
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-group-name}
next-hop-self command.
Parameters
Defaults
Disabled.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
If the set ipv6 next-hop command in the ROUTE-MAP mode is configured, its configuration takes
precedence over the neighbor next-hop-self command.
neighbor peer-group (assigning peers)
c e
Allows you to assign one peer to a existing peer group.
Syntax
neighbor ipv6-address peer-group peer-group-name
To delete a peer from a peer group, use the no neighbor ipv6-address peer-group
peer-group-name command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group
peer-group-name
Enter the keyword peer-group followed by the name of a configured
peer group. (maximum 16 characters)
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale