768 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Usage
Information
You can assign up to 64 peers to one peer group.
When you add a peer to a peer group, it inherits all the peer group’s configured parameters. A peer
cannot become part of a peer group if any of the following commands are configured on the peer:
• neighbor advertisement-interval
• neighbor distribute-list out
• neighbor filter-list out
• neighbor next-hop-self
• neighbor route-map out
• neighbor route-reflector-client
• neighbor send-community
A neighbor may keep its configuration after it was added to a peer group if the neighbor’s
configuration is more specific than the peer group’s, and the neighbor’s configuration does not affect
outgoing updates.
A peer group must exist before you add a peer to it. If the peer group is disabled (shutdown) the peers
within the group are also disabled (shutdown).
Related
Commands
neighbor peer-group (creating group)
c e
Allows you to create a peer group and assign it a name.
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
Usage
Information
When a peer group is created, it is disabled (shut mode).
Related
Commands
capture bgp-pdu max-buffer-size Resets BGP sessions.
neighbor peer-group (creating group) Create a peer group.
show ip bgp ipv6 unicast peer-group View BGP peers.
show ip bgp ipv6 unicast neighbors View BGP neighbors configurations.
peer-group-name
Enter a text string up to 16 characters long as the name of the peer group.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
neighbor peer-group (assigning peers) Assign routers to a peer group.
To Next Page
Loading...
