Control and Monitoring | 77
Command
History
Usage
Information
A MOTD banner message is displayed only in EXEC Privilege mode after entering the enable
command followed by the password. These banners are not displayed to users in EXEC (non-privilege)
mode.
Related
Commands
cam-audit linecard
e
Enable audit of the IPv4 forwarding table on all line cards.
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
Enables periodic audits of software and hardware copies of the IPv4 forwarding table.
clear alarms
c e s
Clear alarms on the system.
Syntax
clear alarms
Command Modes
EXEC Privilege
Command
History
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
banner exec Sets a banner to be displayed when you enter the EXEC Privilege mode.
banner login Sets a banner to be displayed after successful login to the system.
all Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on the IPv4
forwarding entries.
interval time-in-minutes Enter the keyword interval followed by the frequency in minutes of the
CAM audit.
Range: 5 to 1440 minutes (24 hours)
Default: 60 minutes
Version 7.4.1.0 Introduced on E-Series
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
To Next Page
Loading...
