Dell Force10 TeraScale E Series - Page 74

74 | Control and Monitoring
www.dell.com | support.dell.com
audible cut-off
e
Turn off an audible alarm.
Syntax
audible cut-off
Defaults
Not configured.
Command Modes
EXEC Privilege
banner exec
c e s
Configure a message that is displayed when a user enters the EXEC mode.
Syntax
banner exec c line c
Parameters
Defaults
No banner is displayed.
Command Modes
CONFIGURATION
Command
History
ip ftp source-interface show switch links
ip ftp username show system (S-Series)
ip telnet server enable show tech-support (C-Series and E-Series)
ip telnet source-interface show tech-support (S-Series)
ip tftp source-interface ssh-peer-rpm
line telnet
linecard telnet-peer-rpm
module power-off terminal length
motd-banner terminal xml
ping traceroute
power-off undebug all
power-on upload trace-log
reload virtual-ip
reset write
rpm <slot> location-led
c Enter the keywords banner exec, and then enter a character delineator, represented
here by the letter
c, and press ENTER.
line
Enter a text string for your banner message ending the message with your delineator.
In the example below, the delineator is a percent character (%); the banner message is
“testing, testing”.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series