IPv6 Border Gateway Protocol (IPv6 BGP) | 777
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
The E-Series software resolves the network address configured by the network command with the
routes in the main routing table to ensure that the networks are reachable via non-BGP routes and
non-default routes.
Related
Commands
network backdoor
c e
Specify this IGP route as the preferred route.
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length backdoor command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
mask
Enter the mask of the IP address in the slash prefix length format (for
example, /24).
The mask appears in command outputs in dotted decimal format
(A.B.C.D).
route-map map-name (OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
redistribute Redistribute routes into BGP.
ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the
/x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zeros.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
To Next Page
Loading...
