Dell Force10 TeraScale E Series - Page 928

928 | Multicast Source Discovery Protocol (MSDP)
www.dell.com | support.dell.com
Defaults
Not configured
Command Modes
EXEC Privilege
Command
History
clear ip msdp sa-cache
e
Clears the entire source-active cache, the source-active entries of a particular multicast group, rejected,
or local source-active entries.
Syntax
clear ip msdp sa-cache [group-address | rejected-sa | local]
Parameters
Defaults
Without any options, this command clears the entire source-active cache.
Command Modes
EXEC Privilege
Command
History
debug ip msdp
e
Turn on MSDP debugging.
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address | packet peer address |
pim} command.
Parameters
Defaults
Not configured
Command Modes
EXEC Privilege
Version 6.2.1.1 Introduced
group-address
Enter the group IP address in dotted decimal format (A.B.C.D.)
rejected-sa
Enter this keyword to clear the cache source-active entries that are rejected because
the RPF check failed, an SA filter or limit is configured, the RP or MSDP peer is
unreachable, or because of a format error.
local
Enter this keyword to clear out local PIM advertised entries. It applies the
redistribute filter (if present) while adding the local PIM SA entries to the SA cache.
Version 7.8.1.0
Added
local option.
Version 7.7.1.0
Added
rejected-sa option.
Version 6.2.1.1 Introduced
event peer address
Enter the keyword event followed by the peer address in a dotted decimal
format (A.B.C.D.).
packet peer address Enter the keyword packet followed by the peer address in a dotted decimal
format (A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.