Dell Force10 TeraScale E Series - Page 929

Multicast Source Discovery Protocol (MSDP) | 929
Command
History
ip msdp cache-rejected-sa
e
Enable a MSDP cache for the rejected source-active entries.
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-rejected-sa
{number} command followed by the ip msdp cache-rejected-sa {number} command.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Related
Commands
ip msdp default-peer
e
Define a default peer from which to accept all Source-Active (SA) messages.
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address} list name
command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
If a list is not specified, all SA messages received from the default peer are accepted. You can enter
multiple default peer commands.
Version 6.2.1.1 Introduced
number
Enter the number of rejected SA entries to cache.
Range: 0 to 32766
Version 7.4.1.0 Introduced
show ip msdp sa-cache rejected-sa Description.
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.)
list name
Enter this keyword and specify a standard access list that contains the RP address
that should be treated as the default peer. If no access list is specified, then all SAs
from the peer are accepted.
Version 7.8.1.0
Added the
list option, and removed the prefix-list option.
Version 6.2.1.1 Introduced