930 | Multicast Source Discovery Protocol (MSDP)
www.dell.com | support.dell.com
ip msdp log-adjacency-changes
e
Enable logging of MSDP adjacency changes.
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
ip msdp mesh-group
e
Configure a peer to be a member of a mesh group.
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group {name} {peer address}
command.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
A MSDP mesh group is a mechanism for reducing SA flooding, typically in an intra-domain setting.
When some subset of a domain’s MSDP speakers are fully meshed, they can be configured into a
mesh-group. If member X of a mesh-group receives a SA message from an MSDP peer that is also a
member of the mesh-group, member X accepts the SA message and forwards it to all of its peers that
are not part of the mesh-group.However, member X can not forward the SA message to other members
of the mesh-group.
ip msdp originator-id
e
Configure the MSDP Originator ID.
Syntax
ip msdp originator-id {interface}
To remove the originator-id, use the no ip msdp originator-id {interface} command.
Version 6.2.1.1 Introduced
name
Enter a string of up to 16 characters long for as the mesh group name.
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.)
Version 6.2.1.1 Introduced
To Next Page
Loading...
