Dell Force10 TeraScale E Series - Page 931

Multicast Source Discovery Protocol (MSDP) | 931
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
ip msdp peer
e
Configure an MSDP peer.
Syntax
ip msdp peer peer address [connect-source] [description] [sa-limit number]
To remove the MSDP peer, use the no ip msdp peer peer address [connect-source interface]
[description name] [sa-limit number] command.
Parameters
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a number from
0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
Version 6.2.1.1 Introduced
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.)
connect-source
interface
(OPTIONAL) Enter the keyword connect-source followed by one of the
interfaces and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by
a number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512
for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.