960 | Multicast
www.dell.com | support.dell.com
mac-flood-list
e
Provide an exception to the restrict-flood configuration so that multicast frames within a specified
MAC address range to be flooded on all ports in a VLAN.
Syntax
mac-flood-list mac-address mask vlan vlan-list [min-speed speed]
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
When the mac-flood-list with the min-speed option is used in combination with the restrict-flood
command, mac-flood-list command has higher priority than the restrict-flood command.
Therefore, all multicast frames matching the mac-address range specified using the mac-flood-list
command are flooded according to the mac-flood-list command. Only the multicast frames not
matching the mac-address range specified using the mac-flood-list command are flooded according
to the restrict-flood command.
Related
Commands
mac-address
Enter a multicast MAC address in hexadecimal format.
mac-mask
Enter the MAC Address mask.
vlan vlan-list
Enter the VLAN(s) in which flooding will be restricted. Separate values by
commas—no spaces ( 1,2,3 ) or indicate a list of values separated by a
hyphen (1-3).
Range: 1 to 4094
min-speed min-speed
(OPTIONAL) Enter the minimum link speed that ports must have to receive
the specified flooded multicast traffic.
Version 7.7.1.0 Introduced on E-Series
restrict-flooding
Prevent Layer 2 multicast traffic from being forwarded on ports below a
specified speed.
To Next Page
Loading...
