Multicast | 963
restrict-flooding
e
t
Prevent Layer 2 multicast traffic from being flooded on ports below a specified link speed.
Syntax
restrict-flooding multicast min-speed speed
Parameters
Defaults
None
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
This command restricts flooding for all unknown multicast traffic on ports below a certain speed. If
you want some multicast traffic to be flooded on slower ports, use the command mac-flood-list
without the min-speed option, in combination with restrict-flooding. With mac-flood-list you
specify the traffic you want to be flooded using a MAC address range.
You may not use unicast MAC addresses when specifying MAC address ranges, and do not overlap
MAC addresses ranges, when creating multiple mac-flood-list entries for the same VLAN. Restricted
Layer 2 Flooding is not compatible with MAC accounting or VLANs.
Related
Commands
min-speed min-speed
Enter the minimum link speed that a port must have to receive flooded
multicast traffic.
Range: 1000
Version 7.7.1.0 Introduced on E-Series TeraScale
mac-flood-list Flood multicast frames with specified MAC addresses to all ports in a
VLAN.
To Next Page
Loading...
