Dell Force10 TeraScale E Series - Page 962

962 | Multicast
www.dell.com | support.dell.com
queue backplane multicast
e
Reallocate the amount of bandwidth dedicated to multicast traffic.
Syntax
queue backplane multicast bandwidth-percentage percentage
Parameters
Defaults
80% of the scheduler weight is for unicast traffic and 20% is for multicast traffic by default.
Command Modes
CONFIGURATION
Command
History
Example
Figure 35-1. queue backplane multicast Command Example
Related
Commands
percentage
Enter the percentage of backplane bandwidth to be dedicated to multicast
traffic.
Range: 5-95
Version 7.7.1.0 Introduced on E-Series
FTOS(conf)#queue backplane multicast bandwidth-percent 30
FTOS(conf)#exit
FTOS#00:14:04: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by
console
show run | grep bandwidth
queue backplane multicast bandwidth-percent 30
FTOS#
show queue backplane
multicast
Display the backplane bandwidth configuration about how much bandwidth is
dedicated to multicast versus unicast.