(Four port HBA only) IPv4 address for storage controller module 1: port 3 ___ . ___ . ___ . ___
(Four port HBA only) IPv4 address for storage controller module 2: port 3 ___ . ___ . ___ . ___
Table 10. iSCSI Fault Domain 2
Target IPv4 address ___ . ___ . ___ . ___
Subnet mask ___ . ___ . ___ . ___
Gateway IPv4 address ___ . ___ . ___ . ___
IPv4 address for storage controller module 1: port 2 ___ . ___ . ___ . ___
IPv4 address for storage controller module 2: port 2 ___ . ___ . ___ . ___
(4-port HBA only) IPv4 address for storage controller module 1: port 4 ___ . ___ . ___ . ___
(4-port HBA only) IPv4 address for storage controller module 2: port 4 ___ . ___ . ___ . ___
Additional Storage Center Information
The Network Time Protocol (NTP) and Simple Mail Transfer Protocol (SMTP) server information is optional. The proxy server information is
also optional, but it may be required to complete the
Discover and Congure Uninitialized Storage Centers wizard.
Table 11. NTP, SMTP, and Proxy Servers
NTP server IPv4 address ___ . ___ . ___ . ___
SMTP server IPv4 address ___ . ___ . ___ . ___
Backup SMTP server IPv4 address ___ . ___ . ___ . ___
SMTP server login ID ________________
SMTP server password ________________
Proxy server IPv4 address ___ . ___ . ___ . ___
Fibre Channel Zoning Information
For a storage system with Fibre Channel front-end ports, record the physical and virtual WWNs of the Fibre Channel ports in Fault Domain
1 and Fault Domain 2. This information is displayed on the Review Front-End page of the Discover and Congure Uninitialized Storage
Centers wizard. Use this information to congure zoning on each Fibre Channel switch.
Table 12. Physical WWNs in Fault Domain 1
Physical WWN of storage controller 1: port 1 ________________
Physical WWN of storage controller 2: port 1 ________________
(4-port HBA only) Physical WWN of storage controller 1: port 3 ________________
(4-port HBA only) Physical WWN of storage controller 2: port 3 ________________
100 Worksheet to Record System Information