Dell SCv3000 Deployment Guide

Set System Information
Use the Set System Information page to provide Storage Center and storage controller conguration information. This information is
needed when connecting to the
Storage Center using Storage Manager.
1 Type a descriptive name for the Storage Center in the Storage Center Name eld.
2 Type the system management IPv4 address for the Storage Center in the Virtual Management IPv4 Address eld.
The virtual management IPv4 address is the IP address used to manage the Storage Center. The virtual management IPv4 address is
dierent than the storage controller management IPv4 addresses.
3 Type the management IPv4 address for the top storage controller in the Top Controller Management IPv4 Address eld.
4 Type the management IPv4 address for the bottom storage controller in the Bottom Controller Management IPv4 Address eld.
NOTE: The storage controller management IPv4 addresses and virtual management IPv4 address must be within the same
subnet.
5 Type the subnet mask of the management network in the Subnet Mask eld.
6 Type the gateway address of the management network in the Gateway IPv4 Address eld.
7 Type the domain name of the management network in the Domain Name eld.
8 Type the DNS server addresses of the management network in the DNS Server and Secondary DNS Server elds.
9 Click Next.
The Set Administrator Information page opens.
Set Administrator Information
Use the Set Administrator Information page to set a new password and an email address for the Admin user.
1 Type a new password for the default Storage Center administrator user in the New Admin Password and Conrm Password elds.
2 Type the email address of the default Storage Center administrator user in the Admin Email Address eld.
3 Click Next.
• For a storage system with Fibre Channel ports, the Conrm Conguration page opens.
• For a storage system with iSCSI ports, the Congure iSCSI Fault Tolerance page opens.
• For a storage system with front-end SAS ports, the Conrm Conguration page opens.
4 Verify the information and click Apply Conguration. After you click Apply Conguration, you will not be able to change the
information until after the Storage Center is fully congured.
Conrm the Storage Center Conguration
Make sure that the conguration information shown on the Conrm Conguration page is correct before continuing.
1 Verify that the Storage Center settings are correct.
2 If the conguration information is correct, click Apply Conguration.
If the conguration information is incorrect, click Back and provide the correct information.
NOTE
: After you click the Apply Conguration button, the conguration cannot be changed until after the Storage Center is
fully congured.
Initialize the Storage Center
The Storage Center sets up the storage system using the information provided on the previous pages.
1 The Storage Center performs system setup tasks. The Initialize Storage Center page displays the status of these tasks.
To learn more about the initialization process, click More information about Initialization.
Discover and
Congure the Storage Center 61

Dell SCv3000 Specifications

General

HDD speed	10000 RPM
Storage drive size	3.5 \
Storage drive capacity	900 GB
Storage drive interface	Serial Attached SCSI (SAS)
Storage drives installed	Yes
Installed storage drive type	HDD
Total installed storage capacity	6.3 TB
Maximum supported storage capacity	- TB
Number of storage drives installed	7
Number of storage drives supported	16
USB connectivity	-
Chassis type	Rack (3U)
Product color	Black, Grey
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power supply unit (PSU) capacity	1485 W
Storage temperature (T-T)	-40 - 65 °C
Operating temperature (T-T)	10 - 35 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 80 %
Dell E-Value Code	SCv3000FC

Weight and Dimensions

Depth	785 mm
Width	445 mm
Height	133.3 mm