Dell SCv3000 - Connect the Management Ports to the Management Network; Labeling the Ethernet Management Cables

NOTE: If deploying vSphere hosts, congure only one host at a
time.
Connect the Management Ports to the Management
Network
Connect the management port on each storage controller to the management network.
About this task
Figure 42. Connect the Management Ports to the Management Network
1
Management network 2 Ethernet switch
3 SCv3000 and SCv3020 storage system
Steps
1 Connect the Ethernet switch to the management network.
2 Connect the management ports to the Ethernet switch.
• Connect the management port on the top storage controller to the Ethernet switch.
• Connect the management port on the bottom storage controller to the Ethernet switch.
Labeling the Ethernet Management Cables
Label the Ethernet management cables that connect each storage controller to an Ethernet switch.
Prerequisite
Locate the Ethernet management cable labels that shipped with the SCv3000 and SCv3020 storage system.
About this task
Apply cable labels to both ends of each Ethernet management cable.
Steps
1 Starting with the top edge of the label, attach the label to the cable near the connector.
Connect the Front-End Cabling
49