Delta Electronics ASDA-B2 series User Manual

Chapter 7 Servo Parameters ASDA-B2
7-80 Revision September 2013
P3-03
FLT Transmission Fault Treatment
Address: 0306H
0307H
Operation
Interface:
Keypad / Software Communication
Related Section:
Section 8.2
Default: 0
Control
Mode:
ALL
Unit: N/A
Range: 0 ~ 1
Data Size: 16-bit
Display
Format:
Hexadecimal
Settings:
0: Display fault and continue operating
1: Display fault and decelerate to stop operating
This parameter is used to determine the operating sequence once a communication
fault has been detected. If '1' is selected, the drive will stop operating upon detection
the communication fault. The mode of stopping is set by parameter P1-32.
P3-04
CWD Communication Time Out Detection
Address: 0308H
0309H
Operation
Interface:
Keypad / Software Communication
Related Section:
Section 8.2
Default: 0
Control
Mode:
ALL
Unit: sec
Range: 0 ~ 20
Data Size: 16-bit
Display
Format:
Decimal
Settings:
This parameter is used to set the maximum permissible time before detecting a fault
due to communication time out. When P3-04 is set to a value over than 0, it indicates
this parameter is enabled. However, if not communicating with the servo in this period
of time, the servo drive will assume the communication has failed and show the
communication error fault message.
When P3-04 is set to 0, this parameter is disabled.
P3-05 CMM Communication Selection
Address: 030AH
030BH
Operation
Interface:
Keypad / Software Communication
Related Section:
Section 8.2
Default: 0
Control
Mode:
ALL
Unit: N/A
Range: 0x00 ~ 0x01
Data Size: 16-bit
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.

Delta Electronics ASDA-B2 series Specifications

General

Brand	Delta Electronics
Model	ASDA-B2 series
Category	Servo Drives
Language	English