Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
s
2ch Direct/Stereo
Make speaker settings for 2-channel mode playback.
Setting
To change the settings, select “Custom”.
[Selectable items] Basic
z
Custom
Front
Select front speaker size.
[Selectable items] Large
Small
Subwoofer
Select subwoofer use.
[Selectable items] Yes
No
Subwoofer Mode
Select low range signal to be reproduced by subwoofer.
[Selectable items] LFE
LFE+Main
Crossover
Select crossover frequency from which subwoofer handles low range
signal.
[Selectable items]
40Hz
60Hz
80Hz
90Hz
100Hz
110Hz
120Hz
150Hz
200Hz
250Hz
Distance FL
Set distance from listening position to front left speaker.
[Variable range] 0.00m ~ 18.00m
Distance FR
Set distance from listening position to front right speaker.
[Variable range] 0.00m ~ 18.00m
d
Downmix Option
Set dynamic range for downmix playback of Dolby Digital
sources.
[Selectable items] ON
OFF
• Set this to “ON” if the sound from the front speakers seems
distorted.
• When not using the center speaker or surround speakers, the
playback sound is down-mixed and output from the front speakers.
f
Auto Surround Mode
Make setting for memorizing surround mode setting for
each input signal type.
[Selectable items] ON
OFF
• The auto surround mode function lets you store in the memory the
surround mode last used for playing the four types of input signals
listed below.
q Analog and PCM 2-channel signals
w Dolby Digital and DTS 2-channel signals
e Dolby Digital and DTS multi-channel signals
r Multi-channel signals other than Dolby Digital and DTS (PCM,
DSD, etc.)
• When playing in the PURE DIRECT mode, the surround mode does
not change even if the input signal is changed.
g
Manual EQ
Adjust tonal quality for each speaker using graphic
equalizer.
Adjust CH
Select speaker adjustment method.
[Selectable items]
Each
L/R
All
Manual EQ
Select the speaker and frequency band and adjust the level.
[Selectable items] 63
125
250
500
1k
2k
4k
8k
16k
Curve Copy
Copy the Room EQ’s “Audyssey Flat” correction curve.
[Selectable items] Yes
No
“Curve Copy” is displayed after the auto setup procedure has been
performed.
Default
Resets the settings to the default values.
[Variable range] –20dB
~
0dB
~
+6dB
z: Use the same settings as in “Speaker Setup”.
Setup
To Next Page
Loading...
