Denon AVR-3808 User Manual


Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
ENGLISH
<ON/STANDBY> <POWER>
<PHONES>SOURCE SELECT MASTER VOLUME
Playback
Playing Video and Audio Equipment
1
Prepare the equipment.
q Load the DVD, CD or other software in the player.
(vSee the operating instructions of the respective devices.)
w To play a video device, switch the monitor input.
(vSee the monitor’s operating instructions.)
2
To operate using the main remote control unit, set the
remote control unit to the AMP mode.
(vpage 60 “Remote Control Unit Operations”)
3
Use SOURCE SELECT to select the input source.
3
: “Source Select” (vpage 37)
4
Start playback.
(vSee the operating instructions of the respective devices.)
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Preparations
1
Press <POWER>.
The power indicator lights red and the power is set to the standby
mode.
2
Press <ON/STANDBY> or [POWER ON].
The power indicator fl ashes green and the power turns on.
To operate the AVR-3808 using the main remote control unit, set the
remote control unit to the AMP mode (vpage 60 “Remote Control
Unit Operations”).
Turning the Power Off
q Press <ON/STANDBY> or [POWER OFF].
The power is set to the standby mode.
w Press <POWER>.
The power indicator turns off, and so does the power.
NOTE
Power continues to be supplied to some of the circuitry even when
the power is in the standby mode. When leaving home for long periods
of time or when traveling, either press <POWER> to turn off the power,
or unplug the power cord from the power outlet.
Turning the Power On
Either turn <MASTER VOLUME> or press [MASTER
VOLUME].
Press [MUTE].
To cancel, press [MUTE] again. Muting can also be canceled by adjusting
the master volume.
Plug the headphones into <PHONES>.
The sound from the speakers and pre-out connectors is automatically
cut.
NOTE
Be careful not to set the volume too high when using headphones.
Operations During Playback
Adjusting the Master Volume
Turning Off the Sound Temporarily (Muting)
Listening with Headphones
Basic Operation
[POWER ON]
[MUTE]
[POWER OFF]
MASTER VOLUME
SOURCE SELECT
[ AMP]
Playback
1.AVR3808E2_ENG_104.indd 51 2007/10/25 15:17:43

Denon AVR-3808 Specifications

General

Type	AV Receiver
Channels	7.1
Power Output per Channel	130 W (8 ohms, 20 Hz - 20 kHz, 0.05% THD)
HDMI Inputs	4
HDMI Outputs	2
Network Connectivity	Ethernet
THD	0.05%
Component Video Inputs	3
Component Video Outputs	1
Digital Audio Inputs (Coaxial)	2
Preamp Outputs	7.1
Weight	15.5 kg
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
Input Sensitivity/Impedance	200 mV / 47 kOhms
Signal-to-Noise Ratio	100 dB
HDMI Version	1.3a
Supported Video Formats	1080p
Dolby Technologies	Dolby Digital, Dolby Digital EX, Dolby TrueHD, Dolby Pro Logic IIx
DTS Technologies	DTS-HD Master Audio
Multi-room Zones	3
Video Inputs/Outputs	Composite
Audio Inputs/Outputs	Analog, Digital Optical, Digital Coaxial