Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
[Selectable items]
f
RESTORER
This function restores compressed audio signals to how
they were before compression and corrects the sense of
volume of the bass and treble to obtain richer playback
sound.
0 ms
~
200 ms
OFF
Low
Middle
High
h
Audio Delay
Compensate for mismatched timing between video and
audio.
g
Night Mode
Optimized setting for late-night listening.
[Selectable items]
Operating from the main remote control unit
Press the NGT button.
The “ ” indicator lights when “Low”, “Middle” or “High” is
selected.
[Variable range]
Delay audio.
This sets the delay time for audio signals.
• This cannot be adjusted when playing in the EXT. IN, DIRECT or
STEREO mode (with “Front” set to “Large”, “Tone Defeat” to “ON”
and “Room EQ” to “OFF”.)
• The adjustment range is 0 to 100 ms when the Auto Lipsync
Correction function is activated.
Operating from the main unit or main remote
control unit
q Press the AUDIO DELAY button on the main unit or the A. DL button
on the main remote control unit.
w Use the o p button to set.
d
Room EQ
Select room equalizer for current environment.
[Selectable items]
Operating from the main unit or main remote
control unit
Press the ROOM EQ button on the main unit or the EQ button on the
main remote control.
When “Audyssey” is selected, “ ” lights.
When “Audyssey Byp. L/R” or “Audyssey Flat” is selected, or when
the auto setup measuring results have changed, “ ” lights.
• “Audyssey”, “Audyssey Byp. L/R” and “Audyssey Flat” can be
selected after the auto setup procedure has been performed.
• If the settings of the speakers for which “None” has been determined
at “Auto Setup” are changed, “Audyssey”, “Audyssey Byp. L/R” and
“Audyssey Flat” cannot be selected and measurements have to be
taken again to include the newly-added speakers.
• When using headphones, “Room EQ” is always set to “OFF”.
About the RESTORER function
• Such compressed audio formats as MP3, WMA (Windows Media
Audio) and MPEG-4 AAC reduce the amount of data by eliminating
signal components that are hard for the human ear to hear. The
RESTORER function generates the signals eliminated upon
compression, restoring the sound to conditions near those of the
original sound before compression. It also corrects the sense of
volume of the bass to obtain richer sound with compressed audio
signals.
• This is displayed on the GUI menu and can be set when the input
source is set to “NET/USB” or when analog signals (including AM/
FM signals) or PCM signals (fs = 44.1/48 kHz) are input.
Operating from the main unit or main remote
control unit
During playback, press the RESTORER button on the main unit or the
RSTR button on the main remote control unit.
When set to something other than “OFF”, “ ” is displayed.
The default setting for “NET/USB” and “iPod” is “Mode3”. All others
are set to “OFF”.
OFF
OFF
High
Low Middle
Setup
OFF
Mode1
(RESTORER 64)
Mode2
(RESTORER 96)
Mode3
(RESTORER HQ)
Audyssey
: Optimize frequency response of all speakers.
Audyssey Byp. L/R
: Optimize frequency response of speakers
except front L and R speakers.
Audyssey Flat
: Optimize frequency response of all speakers to
flat response.
Manual
: Apply frequency response set with “Manual
EQ” (vpage 31).
OFF
: Turn equalizer off.