Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Network Setup
Make network settings.
F Menu tree F
Manual Setup
Network Setup
a Network Setup
s Other
d Network Information
a
Network Setup
Make settings for LAN.
To acquire the IP address automatically
using the DHCP function
To enter the IP address manually
Turn on the AVR-3808’s power.
At the GUI menu “Manual Setup” – “Network
Setup” – “Detail” setting, set “DHCP” to “OFF”
and enter the IP address, subnet mask, default
gateway, primary DNS and secondary DNS.
To not pass through the proxy server To connect via proxy server
At the GUI menu “Manual Setup” – “Network
Setup” – “Proxy” setting, set “Proxy” to “ON”
and enter the address or domain name and
port numbers.
This setting is required when the network
is established via proxy servers.
Recheck the connections and settings if you cannot connect to the Internet (vpage 20).
This completes the setting.
NOTE
Knowledge about networks is required to make the IP address and proxy settings. For details, consult a network administrator.
Setup
To Next Page
Loading...
