0
Getting Started Connections Setup Playback Multi-Zone Information Troubleshooting
ENGLISH
Remote Control Unit Operations
Main Remote Control Unit
• On the main remote control unit, the display switches
according to the device being operated and the mode.
• In modes other than iPod, the mode switches between
“ ” and “ ” each time the [MODE SELECTOR] is
pressed.
• In the AMP, TUNER, NET/DTU and iPod modes, when the
remote ID is set, the AVR-3808 can be used independently
even in an environment containing multiple DENON
amplifiers.
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
NOTE
The device mode (“ ” or “ ”) cannot be changed while the
setting is being made.
Operating DENON Audio Components
1
Press [MODE SELECTOR] for the component to be
operated.
The indicator for the component to be operated flashes.
: AMP / ZONE2 / ZONE3 /
ZONE4 / SYSTEM CALL
: TUNER (FM/AM)
: NETWORK/USB /
DIGITAL TUNER
: Satellite Receiver / Cable TV
: iPod
: DVD player (Recorder) /
CD player (Recorder)
: VCR / TAPE
: TV
b The TUNER ( ) and NET/DTU ( ) mode is not used
on the AVR-3808, so use the learn function to store the signals
(vpage 63).
b The mode switches each time [AMP] is pressed.
GAMP modeH GZONE2 modeH GZONE3 mode
H
GSYSTEM CALL modeH GZONE4 modeH
2
Operate the component.
b For details, refer to the component’s operating instructions.
[HOME] is used to return to the AMP mode (AMP, ZONE2, ZONE3,
ZONE4 or SYSTEM CALL) when in any mode other than AMP.
Presetting
The included main remote control unit can be preset to
operate devices of various brands.
1
Press [MODE SELECTOR] for the device you want to
preset.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Press [NUMBER] and input the 5-digit number of the
brand of the component to be preset. The numbers
are shown in the Preset Code Table (v End of this
manual).
When the code is registered, the signal transmission indicator
flashes twice.
When the preset code is transmitted, the mode indicator for the
component to which that code belongs flashes.
b The input mode is canceled if no button is operated for 10
seconds.
Some brands have more than one preset code. If the component does
not operate, try inputting a different code.
Operating Preset Components
1
Press [MODE SELECTOR] for the component to be
operated.
The mode indicator of the device to be operated flashes.
2
Operate the component.
b For details, refer to the component’s operating instructions.
To Next Page
Loading...
Need help?
General
