Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Press <TUNING PRESET>, then turn <SOURCE SELECT>
to select the preset radio station.
Listening to Preset Stations
Operation on the Main Unit
Operation on the Main Remote Control Unit
1
Press [A ~ G] to select the memory block.
2
Press [CHANNEL] or [1 ~ 8] to select the desired preset
channel.
n Default settings
Auto tuner presets
A1 ~ A8
87.5 / 89.1 / 98.1 / 108.0 / 90.1 / 90.1 / 90.1 /
90.1 MHz
B1 ~ B8
522 / 603 / 999 / 1404 / 1611 kHz,
90.1 / 90.1 / 90.1 MHz
C1 ~ C8
90.1 MHz
D1 ~ D8
90.1 MHz
E1 ~ E8
90.1 MHz
F1 ~ F8
90.1 MHz
G1 ~ G8
90.1 MHz
Program Type (PTY)
PTY identifies the type of RDS program.
The program types and their displays are as follows:
NEWS News
AFFAIRS Current Affairs
INFO Information
SPORT Sports
EDUCATE Education
DRAMA Drama
CULTURE Culture
SCIENCE Science
VARIED Varied
POP M
Pop Music
ROCK M
Rock Music
EASY M
Easy Listening
Music
LIGHT M
Light Classical
CLASSICS Serious Classical
OTHER M
Other Music
WEATHER Weather
FINANCE Finance
CHILDREN
Children’s
programmes
SOCIAL Social Affairs
RELIGION Religion
PHONE IN
Phone In
TRAVEL Travel
LEISURE Leisure
JAZZ Jazz Music
COUNTRY Country Music
NATION M
National Music
OLDIES Oldies Music
FOLK M
Folk Music
DOCUMENT Documentary
Traffic Program (TP)
TP identifies programs that carry traffic announcements.
This allows you to easily find out the latest traffic conditions in your
area before leaving home.
Radio Text (RT)
RT allows RDS stations to send text messages that appear on the
display.
NOTE
The operations described below using [SEARCH] will not function in
areas in which there are no RDS broadcasts.
RDS (Radio Data System)
RDS (works only on the FM band) is a broadcasting service
which allows a station to send additional information along
with the regular radio program signal.
The following three types of RDS information can be
received with this unit:
1
Either turn <SOURCE SELECT> or press [TUNER]
(AMP mode) to select “TUNER”.
2
To operate using the main remote control unit, set the
remote control unit to the TUNER ( ) mode.
(vpage 60 “Remote Control Unit Operations”)
3
Press [SEARCH] to select “RDS”.
4
Press [CHANNEL].
The search for RDS stations begins automatically.
b If no RDS stations are found with the above operation, all the
reception bands are searched.
b When a broadcast station is found, that station’s name appears on
the display.
5
To continue searching, repeat steps 2 to 3.
b If no RDS station is found when all the frequencies have been
searched, “NO RDS” is displayed.
RDS Search
Use this function to automatically tune to FM stations that
provide the RDS service.
Playback
To Next Page
Loading...
Need help?
General
