User Manual DEV 2190
Copyright DEV Systemtechnik GmbH 2009-2017 63
After operating the button, the drop down list "Type", the text field
"Description", and a button labeled appear:
With the drop down list, the type of data to be saved can be chosen:
"Module Data"
to store the following data categories for all (!) installed modules:
● "Switch Settings" (if applicable),
● "LNB Power Settings",
● "Gain Settings",
● "Slope Settings" (if applicable),
● "RF Threshold Settings", and
● "Channel Settings and Names".
Please refer to chapters 5.4.4.1…5.4.4.2 for details on these settings and to the
"Restore" section below for retrieving all or only a part of these settings.
"Device Data"
to store device specific settings accessible via the Setup Tab:
● "IP Settings" (chapter 5.4.7.2.1),
● "User Setup" (chapter 5.4.7.1), and
● "General Setup (SNMP, Device Setup,…)"
(chapters 5.4.7.2.2, 5.4.7.3, including the operation mode (chapter 5.1)).
Please refer to the chapters in parentheses for details on these settings and to
the "Restore" section below for retrieving all or only a part of these settings.
"Error Log"
to store the current content of the Events Tab (chapter 5.4.5).
Note that "Error Log" data can neither be restored nor be imported.
For better identification, it is recommended to enter a descriptive name for the
backup set in the "Description" text field before operating the button.
To Next Page
Loading...