Develop ineo 213 - Width and Length; Paper Orientation

Introduction
1
ineo 163/213 1-13
"Width" and "length"
Whenever paper dimensions are
mentioned in this manual, the first value
always refers to the width of the paper
(shown as "X" in the illustration), and the
second value refers to the length (shown
as "Y").
Paper orientation
Lengthwise (w)
If the length (Y) is longer than the width (X),
the paper orientation is indicated by w.
Crosswise (v)
If the length (Y) is shorter than the width (X),
the paper orientation is indicated by v.