Develop ineo 213 - Selecting the Default Density (DENSITY PRIORITY Parameter); Density Priority

Utility mode/Copy mode parameters
7
ineo 163/213 7-59
Selecting the default density ("DENSITY PRIORITY" parameter)
1 Display the "COPY SETTING 1" menu.
– Refer to "Displaying the "COPY SETTING 1" menu" on page 7-55.
2 Press the [+] or [,] key until "DENSITY PRIORITY" is selected, and
then press the [OK] key.
3 Press the [+] or [,] key until "AUTO" or "MANUAL" is selected, and
then press the [OK] key.
The "COPY SETTING 1" menu appears again.
UTILITY MODE
ADMIN. MANAGEMENT
USER MANAGEMENT
COPY SETTING 1
COPY SETTING 1
QUALITY PRIORITY
PAPER PRIORITY
DENSITY PRIORITY
DENSITY PRIORITY
MANUAL
AUTO