Develop ineo 213 - Selecting the Setting for Crisscross Feeding (CRISSCROSS MODE Parameter)

7
Utility mode/Copy mode parameters
7-80 ineo 163/213
Selecting the setting for crisscross feeding ("CRISSCROSS MODE"
parameter)
2
Note
The setting for crisscross feeding cannot be selected if optional shift tray
SF-501 is installed.
1 Display the "COPY SETTING 2" menu.
– Refer to "Displaying the "COPY SETTING 2" menu" on page 7-71.
2 Press the [+] or [,] key until "CRISSCROSS MODE" is selected, and
then press the [OK] key.
UTILITY MODE
RETURN
COPY SETTING 2
COPY SETTING 2
DUPLEX COPY
MIXED ORIGINAL
CRISSCROSS MODE