Develop ineo 213 - Selecting the Default AUTO Density Level (DENSITY LEVEL (A) Parameter)

7
Utility mode/Copy mode parameters
7-60 ineo 163/213
Selecting the default "AUTO" density level ("DENSITY LEVEL (A)"
parameter)
1 Display the "COPY SETTING 1" menu.
– Refer to "Displaying the "COPY SETTING 1" menu" on page 7-55.
2 Press the [+] or [,] key until "DENSITY LEVEL" is selected, and then
press the [OK] key.
3 Press the [+] or [,] key until "AUTO" is selected, and then press the
[OK] key.
UTILITY MODE
ADMIN. MANAGEMENT
USER MANAGEMENT
COPY SETTING 1
COPY SETTING 1
BINDING POSITION
DENSITY LEVEL
MARGIN SETTING
DENSITY LEVEL
MANUAL
AUTO