Develop ineo 213 - Adjusting the Width of the Erased Area (ERASE SETTING Parameter)

Utility mode/Copy mode parameters
7
ineo 163/213 7-67
Adjusting the width of the erased area ("ERASE SETTING" parameter)
1 Display the "COPY SETTING 1" menu.
– Refer to "Displaying the "COPY SETTING 1" menu" on page 7-55.
2 Press the [+] or [,] key until "ERASE SETTING" is selected, and then
press the [OK] key.
3 Press the [+] or [,] key until "LEFT", "UPPER" or "FRAME" is selected,
and then press the [OK] key.
UTILITY MODE
ADMIN. MANAGEMENT
USER MANAGEMENT
COPY SETTING 1
COPY SETTING 1
SMALL ORIGINAL
ERASE SETTING
RETURN
ERASE SETTING
UPPER
LEFT
FRAME