2.2.2. Channel Setup IOLITE®
In the channel setup you can see a preview of the connected devices on the left side.
When you click on a connector in the image the corresponding channel in the Channel setup
grid will automatically be selected. This also works the other way around: when you select a
channel (or multiple channels) in the setup grid, the corresponding connectors in the image
will be highlighted.
The sampling rate will be set for all connected IOLITE® slices: of course only up to the max. sampling rate
of the individual slices.
Channel setup IOLITE-R12
Channel setup IOLITE-R8
To Next Page
Loading...