DEWESOFT IOLITE V22-2 - Ioliter Slices: Mounting;Removing;Replacing from Rack Chassis; Ioliter Slices: Replacing the Slice - Instructions

IOLITE®
TECHNICAL REFERENCE MANUAL
3.3.4. IOLITEr slices: Mounting/Removing/Replacing from Rack Chassis
IOLITE rack slices (IOLITEr) can be mounted in all rack chassis versions: IOLITE-R12, IOLITE-R8 and
IOLITE-R8r.
Warning
When mounting or removing IOLITEr slices TURN OFF the equipment! IOLITEr slice ARE NOT hot
swappable.
3.3.4.1. IOLITEr slices: Replacing the slice - Instructions
Turn off the device!
Unscrew two M2.5x5 TRX panhead screws.
Remove the IOLITEr slice.
Insert the new slice by sliding it on rails.
Screw two M2.5x5 TRX panhead screws.
You are ready to measure!
IOLITE® V22-2 65 / 193