Diamond Systems JACKSON - Usb 3.0;2.0 (J4, J12, J21); Usb 3.0;2.0 (J12)

Jackson User Manual rev 2.2 www.diamondsystems.com Page 33
7.15 USB 3.0/2.0 (J4, J12, J21)
Two USB3.0/USB2.0 ports of the board are accessed with a RA stacked standard connector (J4) as shown
below:
Both top and bottom ports follow the standard pinout.
1
USB_PWR
2
USB2_D-
3
USB2_D+
4
GND
5 USB3_RX-
6
USB3_RX+
7
GND
8 USB3_TX-
9
USB3_TX+
J4 Connector PN: 484060003
Mating Cable PN: Industry-standard USB type A male
7.16 USB 3.0/2.0 (J12)
One USB3.0/USB2.0 port is shared between the expansion conenctor and 2x5 pin header (J12) and follows the
below pinout:
USB3_RX-
1 2
GND_CH
USB3_RX+
3 4
GND
GND
5 6
USB2_D+
USB3_TX-
7 8
USB2_D-
USB3_TX+
9 10
USB_PWR
J12 Connector PN: 98414-G06-10LF
Connector Type: Vertical Header 2mm pitch latching
Mating Cable PN: 6980603