CUBE 30 TOUCH | USER MANUAL
3 INSTALLATION
The CUBE 30 TOUCH is a precision instrument and must be handled as such.
Inappropriate operations may damage the internal optoelectronic components
and cause mechanical damage. Follow the instructions in this chapter in order to
ensure the safety of the instrument and of the operator.
3.1 Transport and handling
The instrument must be transported and handled in its original packaging.
Do not let the instrument or packaging become wet or be exposed to a damp
environment. If the packaged instrument has been exposed to storage or transit
temperatures below 10°C for more than 24 hours, allow the unit to stand at room
temperature for one hour prior to installation.
3.2 Packaging characteristics
The instrument is packed in:
1. an external cardboard box
2. molded housing in CFC- and HCFC-free, closed-cell polyethylene foam
Save the original packaging including the internal parts.
3.3 Materials provided
The CUBE 30 TOUCH is supplied with the following materials:
• User Manual
• One power cable adherent to IEC International Standards (Female Plug IEC 320
C-13; Male Plug Schuko EEC 7-VII; Rating: 10A / 250V AC).
• One power cable SVT PLUG USA/OUTLET VDE UL 2mt
• Two Delayed 5x20 mm UL fuse blocks 10A
• USB cable
• Plastic Adaptor (A in Figure 9 for use with conventional stopper EDTA tubes
To Next Page
Loading...
