Digi Connect EZ Mini User Manual

Serial port Configure Remote Access mode
Digi Connect EZ Mini User Guide
119
(config)>serial port1 service telnet port int
(config)>
where int is any integer between 1 and 65535. The default is 3001.
iii. Enable TCPkeep-alive messages:
(config)>serial port1 service telnet keepalive true
(config)>
iv. Enable TCP nodelay messages:
(config)>serial port1 service telnet nodelay true
(config)>
v. (Optional) Configure access control:
n To limit access to specified IPv4 addresses and networks:
(config)> add serial port1 service telnet acl address end
value
(config)>
Where value can be:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n To limit access to specified IPv6 addresses and networks:
(config)> add serial port1 service telnet acl address6 end
value
(config)>
Where value can be:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 2001:db8::/48.
l any: No limit to IPv6 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n To limit access to hosts connected through a specified interface on the
Connect EZ device:
(config)> add serial port1 service telnet acl interface end
value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:

Digi Connect EZ Mini Specifications

General

Brand	Digi
Model	Connect EZ Mini
Category	Server
Language	English