Hardware Power loss and Connect EZ configuration
Digi Connect EZ Mini User Guide
31
n M4 pan-head Philips screw
n Coarse-thread sheet metal screw
n 12 mm in length. The length should clear the mounting tab thickness and leave at least 1 cm of
screw shank to bite into the mounting material.
Mounting onto thicker metals
Examples: Aluminum or steel.
Use a screw that meets these requirements:
n M4 pan-head Philips screw
n Machine-thread screw
n 12 mm in length. The length should clear the mounting tab thickness and leave at least 1 cm of
screw shank to bite into the mounting material.
Attach to DIN rail with clip
The DIN rail clip and two screws are included with the device. You will need an appropriate Phillips-
head screwdriver. For details about the hardware, see DINrail clip information.
1. Remove required items from DINrail mounting kit:
n DIN rail clip
n Two flat head screws.
2. Place the DIN rail clip on the rear panel of the device. Make sure the screw holes are aligned.
3. In each hole, use a Phillips-head screw driver to screw in a screw.
4. Tighten the screws as needed to securely fasten the DINrail clip to the device.
5. Set the device onto a DIN rail and gently press until the clip snaps into the rail.
Power loss and Connect EZ configuration
The Connect EZ retains its configuration if power is lost and then power is restored when the Hub is
plugged into a main power supply, or if the Hub is commanded to restart automatically or
interactively.
To Next Page
Loading...
Need help?
General