Hardware Use the ERASEbutton to reset your device to the factory defaults
Digi Connect EZ Mini User Guide
32
Use the ERASEbutton to reset your device to the factory defaults
You can reset the Connect EZ to the factory default settings. Resetting the device to factory defaults
performs the following actions:
n Clears all configuration settings.
n All firmware updates are deleted.
n Deletes all user files.
n Regenerates SSH keys.
n Clears event and system log files.
n Creates a new event in the event log, indicating a factory reset.
Note While the settings are reset, the device's firmware version remains the same.
1. Make sure that the Connect EZhas been powered on for at least 30 seconds.
2. Locate the Erase button on the back of the device.
3. Using a pinhole tool, press and briefly hold the Erase button.
4. The device resets to factory defaults and then reboots automatically.
Discover the IPaddress using the Digi Navigator
You can use the Digi Navigator to quickly discover the IP address for the Connect EZ.
Note If you don't have access to the Digi Navigator, you can use a manual method to discover the
IPaddress. See Discover the device'sIPaddress: Additional methods.
1. To ensure that your computer and device are connected to each other and your local network,
make the following connections:
n Connect the device to your computer with an Ethernet cable.
n Connect the device to your local network with an Ethernet cable.
n Connect your computer to your local network with an Ethernet cable.
2. Download and install the Digi Navigator.
3. Launch the Digi Navigator.
To Next Page
Loading...
Need help?
General