Digi Connect EZ Mini

Interfaces Wide Area Networks (WANs)
Digi Connect EZ Mini User Guide
76
(config network interface my_wan ipv4 surelink)> interval 600s
(config network interface my_wan ipv4 surelink)>
The default is 15 minutes.
e. If more than one test target is configured, determine whether the interface should fail
over based on the failure of one of the test targets, or all of the test targets:
(config network interface my_wan ipv4 surelink)> success_condition value
(config network interface my_wan ipv4 surelink>
Where value is either one or all.
f. Set the number of probe attempts before the WAN is considered to have failed:
(config network interface my_wan ipv4 surelink)> attempts num
(config network interface my_wan ipv4 surelink>
The default is 3.
g. Set the amount of time that the device should wait for a response to a probe attempt
before considering it to have failed:
(config network interface my_wan ipv4 surelink)> timeout value
(config network interface my_wan ipv4 surelink>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set parameter name to ten minutes, enter either 10m or 600s:
(config)> path-param 600s
(config)>
The default is 15 seconds.
9. (Optional) Repeat this procedure for IPv6.
10. Save the configuration and apply the change:
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Disable SureLink
If your device uses a private APN with no Internet access or has a restricted WAN connection that
doesn't allow DNS resolution, you can disable SureLink connectivity tests. You can also reconfigure
SureLink to disable the DNS test and use one or more other tests.
Web