System administration Configure the speed of your Ethernet port
Digi Connect EZ Mini User Guide
635
n IPaddress for PC: 192.168.210.2
n Subnet: 255.255.255.0
n Gateway: 192.168.210.1
2. Connect the PC's Ethernet port to the Ethernet port on your Connect EZ device.
3. Open a telnet session and connect to the Connect EZ device at the IP address of 192.168.210.1.
4. Log into the device:
n Username: admin
n Password: The default unique password for your device is printed on the device label.
5. At the shell prompt, type:
# rm /etc/config/.nocrypt
# flatfsd -i
This will re-enable encryption and leave the device at its factory default setting.
Configure the speed of your Ethernet port
You can configure the speed of your Connect EZ device's Ethernet port.
Web
To Next Page
Loading...
