Serial port Configure Modem emulator mode
Digi Connect EZ Mini User Guide
142
(config)>serial port1 logging filename string
(config)>
c. Set the maximum allowed log size for the serial port log when starting the log:
(config)>serial port1 logging size value
(config)>
where value is the size of the log file in bytes. The default is 65536.
d. Specify the data type:
(config)>serial port1 logging type value
(config)>
where value is one of:
n received
n transmitted
n both
n arrows. This is the default.
e. Log the time at which date was received or transmitted:
(config)>serial port1 logging hex true
(config)>
f. Log data as hexadecimal values:
(config)>serial port1 logging timestamp true
(config)>
19. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
20. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure Modem emulator mode
Modem emulator mode allows the device to act as a dial-up modem emulator for handling incoming
AT dial-ins.
To change the configuration to match the serial configuration of the device to which you want to
connect:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
To Next Page
Loading...
Need help?
General