Services Enable service discovery (mDNS)
Digi Connect EZ Mini User Guide
426
Enable service discovery (mDNS)
Multicast DNS mDNS is a protocol that resolves host names in small networks that do not have a DNS
server. You can enable the Connect EZ device to use mDNS.
Note This feature is enabled by default.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Service Discovery (mDNS).
4. The mDNS service is enabled by default. To disable, click to toggle off Enable.
5. Click Access control list to configure access control:
n To limit access to specified IPv4 addresses and networks:
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's mDNS
service. Allowed values are:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the mDNS service.
d. Click again to list additional IP addresses or networks.
n To limit access to specified IPv6 addresses and networks:
a. Click IPv6 Addresses.
b. For Add Address, click .
To Next Page
Loading...
Need help?
General