Digi Connect EZ Mini User Manual

Firmware configuration Review Connect EZ default settings
Digi Connect EZ Mini User Guide
39
Review Connect EZ default settings
You can review the default settings for your Connect EZ device by using the local WebUI or Digi
Remote Manager:
Local WebUI
1. Log into the Connect EZ WebUI as a user with Admin access.
2. On the menu, click System > Device Configuration.
Digi Remote Manager
1. If you have not already done so, connect to your Digi Remote Manager account.
2. Click Device Management to display a list of your devices.
3. Locate and select your device as described in Use Digi Remote Manager to view and manage
your device.
4. Click Configure.
The following tables list important factory default settings for the Connect EZ.
Default interface configuration
Interface type
Preconfigured
interfaces Devices Default configuration
Wide Area Networks (WAN)
n Ethernet n ETH n Firewall zone:
Edge
n WAN priority:
Metric=5
n IP Address:
DHCP address
n Digi SureLink
TM
disabled for IPv4
Loopback
n Loopback n Loopback n Firewall zone:
Loopback
n IP address:
127.0.0.1/8
Other default configuration settings
Feature Configuration
Central
management
n Digi Remote Manager enabled as the central management service.

Digi Connect EZ Mini Specifications

General

Brand	Digi
Model	Connect EZ Mini
Category	Server
Language	English