Serial port Configure UDP serial mode
Digi Connect EZ Mini User Guide
141
Repeat this step to list additional IP addresses or networks.
n To limit access to hosts connected through a specified interface on the Connect EZ
device:
(config)> add serial port1 udp acl interface end value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Repeat this step to list additional interfaces.
n To limit access based on firewall zones:
(config)> add serial port1 udp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
---------------------------------------------------------
----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to include additional firewall zones.
18. Configure serial port logging:
a. Enable serial port logging:
(config)>serial port1 logging enable true
(config)>
b. Set the file name:
To Next Page
Loading...
Need help?
General