Digi Connect EZ Mini

Virtual Private Networks (VPN) IPsec
Digi Connect EZ Mini User Guide
214
where value is one of:
o
up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).
o
down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
f. Repeat for each additional test.
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config vpn ipsec tunnel ipsec_example surelink tests 1)> ...
(config)>
b. Add a recovery action:
(config)> add vpn ipsec tunnel ipsec_example surelink actions end
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
c. New actions are enabled by default. To disable:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> enable false
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
d. Create a label for the action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> label string
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
e. Set the type of recovery action to reboot_device:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> action
reboot_device
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
n Set the number of attempts for this recovery action to perform, before moving to
the next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> max_
attempts int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
n Set the time to wait before the next test is run. If set to the default value of 0s, the
test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
f. Set the type of recovery action. If multiple recovery actions are configured, they are
performed in the order that they are listed. The command varies depending on whether
the interface is a WAN or WWAN: