Digi Connect EZ Mini

Virtual Private Networks (VPN) IPsec
Digi Connect EZ Mini User Guide
218
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
g. Repeat for each additional recovery action.
7. Optional SureLink configuration parameters:
a. Type ... to return to the root of the configuration:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> ...
(config)>
b. Set the test interval between connectivity tests:
(config)> vpn ipsec tunnel ipsec_example surelink interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
(config)> vpn ipsec tunnel ipsec_example surelink interval 600s
(config)>
The default is 15m.
c. If more than one test target is configured, set the success condition:
(config)> vpn ipsec tunnel ipsec_example surelink success_condition
value
(config)>
where value is either:
n one: Only one test needs to pass for Surelink to consider an interface to be up.
n all: All tests need to pass for SureLink to consider the interface to be up.
d. Set the number of times that the test must pass after failure, before the interface is
determined to be working and is reinstated.
(config)> vpn ipsec tunnel ipsec_example surelink pass_threshold int
(config)>
The default is 1.
e. Set the amount of time that the device should wait for a response to a test attempt before
considering it to have failed:
(config)> vpn ipsec tunnel ipsec_example surelink timeout value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set timeout to ten minutes, enter either 10m or 600s: