Virtual Private Networks (VPN) OpenVPN
Digi Connect EZ Mini User Guide
269
e. Set the type of recovery action to reboot_device:
(config vpn openvpn client openvpn_client1 surelink actions 0)> action
reboot_device
(config vpn openvpn client openvpn_client1 surelink actions 0)>
n Set the number of attempts for this recovery action to perform, before moving to
the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
The default is 3.
n Set the time to wait before the next test is run. If set to the default value of 0s, the
test interval is used.
(config vpn openvpn client openvpn_client1 surelink actions 0)>
override_interval int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
f. Set the type of recovery action. If multiple recovery actions are configured, they are
performed in the order that they are listed. The command varies depending on whether
the interface is a WAN or WWAN:
n WANinterfaces:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
action value
(config vpn openvpn client openvpn_client1 surelink actions 0)>
n WWAN interfaces:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
modem_action value
(config vpn openvpn client openvpn_client1 surelink actions 0)>
where value is one of:
n update_routing_table: Increases the interface's metric to change the default
gateway.
If update_routing_table is selected, complete the following:
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn openvpn client openvpn_client1 surelink actions 0)>
max_attempts int
(config vpn openvpn client openvpn_client1 surelink actions 0)>
The default is 3.
l Set the amount that the interface's metric should be increased. This should be
set to a number large enough to change the routing table to use another
default gateway.
To Next Page
Loading...
Need help?
General