Services Configure DNS
Digi Connect EZ Mini User Guide
354
8. (Optional) Allow localhost rebinding is enabled by default if Rebind protection is enabled.
This is useful for Real-time Black List (RBL) servers.
9. (Optional) To add additional DNS servers:
a. Click DNS servers.
b. For Add Server, click .
c. (Optional) Enter a label for the DNS server.
d. For DNS server, enter the IP address of the DNS server.
e. Domain restricts the device's use of this DNS server based on the domain. If no domain are
listed, then all queries may be sent to this server.
10. (Optional) To add host names and their IP addresses that the device's DNS server will resolve:
a. Click Additional DNS hostnames.
b. For Add Host, click .
c. Type the IP address of the host.
d. For Name, type the hostname.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect EZ local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure access control:
n To limit access to specified IPv4 addresses and networks:
(config)> add service dns acl address end value
(config)>
Where value can be:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the DNS service.
Repeat this step to list additional IP addresses or networks.
n To limit access to specified IPv6 addresses and networks:
(config)> add service dns acl address6 end value
(config)>
Where value can be:
To Next Page
Loading...
Need help?
General