Interfaces Wide Area Networks (WANs)
Digi Connect EZ Mini User Guide
65
l Set the hostname or IP address of the host to create a TCPconnection to:
(config network interface my_wan surelink tests 1)> tcp_host
hostname/IP_address
(config network interface my_wan surelink tests 1)>
l Set the TCP port to create a TCPconnection to.
(config network interface my_wan surelink tests 1)> tcp_port
port
(config network interface my_wan surelink tests 1)>
n other: Tests the status of another interface.
If other is selected, complete the following:
l Set the interface to test.
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config network interface my_wan surelink tests 1)> other_
interface /network/interface/eth1
(config network interface my_wan surelink tests 1)>
l Set the type of IP connection:
(config network interface my_wan surelink tests 1)> other_ip_
version value
(config network interface my_wan surelink tests 1)>
where value is one of:
o
any: Either the IPv4 or IPv6 connection must be up.
o
both: Both the IPv4 or IPv6 connection must be up.
o
ipv4 The IPv4 connection must be up.
o
ipv6: The IPv6 connection must be up.
l The status required for the test to past.
(config network interface my_wan surelink tests 1)> other_
status value
(config network interface my_wan surelink tests 1)>
where value is one of:
o
up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).
o
down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
f. Repeat for each additional test.
To Next Page
Loading...
Need help?
General