Interfaces Wide Area Networks (WANs)
Digi Connect EZ Mini User Guide
91
1. Log into the Connect EZ WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect EZ local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network command at the Admin CLI prompt:
> show network
Interface Proto Status Address
---------------- ----- ------- -------------------------------
defaultip IPv4 up 192.168.210.1/24
defaultlinklocal IPv4 up 169.254.100.100/16
eth2 IPv4 up 192.168.2.1/24
eth2 IPv6 up fd00:2704::1/48
loopback IPv4 up 127.0.0.1/8
>
3. Additional information can be displayed by using the show network verbose command:
> show network verbose
Interface Proto Status Type Zone Device Metric
Weight
---------------- ----- ------- ------ -------- -------- ------ ----
--
defaultip IPv4 up static setup eth2 10 10
defaultlinklocal IPv4 up static setup eth2 0 10
eth2 IPv4 up static internal eth2 5 10
eth2 IPv6 up static internal eth2 5 10
loopback IPv4 up static loopback loopback 0 10
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific WAN. For example, to display information about ETH1, enter show
network interface eth1:
> show network interface eth1
wan1 Interface Status
---------------------
Device : eth1
To Next Page
Loading...
Need help?
General